Product Link: http://bit.lc/4zUt
Manual Link: http://img.banggood.com/file/product...r%20Manual.pdf
Firmware Update Instructions:
Version Updating:
flysky i6s 1.10 22-Mar-2016 to flysky i6s 1.11 30-Jun
Need to bind with receiver again, 2. The menu set contents will be reset, please reset your transmitter.
flysky i6s 1.11 07-Jun-2016 to flysky i6s 1.11 30-Jun
Need to reset and calibrate the stick date. Please follow the calibration process to calibrate your transmitter.
Upgrade Process:
1. Connected the transmitter to the computer via USB cable.
2. Enter the Setup menu in the transmitter and navigate the Firmware Update section.
3. Open the firmware upgrade tool in your PC.
4. In the Firmware Update Section of the transmitter press Continue and the transmitter will enter the update mode.
5. Once the transmitter enters the update mode, you will see it listed in the software. Press Update in the software and the update process will begin. It should take a few seconds for the update to take place and then the transmitter will reboot.
6. Close the software and unplug the transmitter.
7. In the Setup section of the transmitter navigate to the About FS-i6S section to confirm the correct firmware.
Once the transmitter’s software has been successfully updated, it must be calibrated. Follow the following steps to calibrate your transmitter:
1- Enter the Setup menu and navigate to the Stick Adjust section to initiate the calibration process.
2-
...Continue Reading