enracer's blog View Details
Posted by enracer | Dec 11, 2013 @ 08:12 PM | 2,719 Views
Here's another PVC rack I made to put my planes on the wall in the garage. These are made from 1-inch PVC as well. For reference, the posts that hold the planes are 20" long and the vertical distance between them is 10".
Posted by enracer | Dec 11, 2013 @ 05:05 PM | 3,384 Views
Here's a PVC rack I made to hold two planes in the back of my truck.

It's made with 1-inch PVC and fittings, and the total height is 36 inches so it would fit under the truck cap. I also added a lip at the back end so I can put my radio and toolbox behind it and they won't slide forward into the planes. If you choose to omit this, you'll only need 8 x elbow fittings.

All measurements on the diagram are the lengths of cut - the finished length will be about 2 inches shorter since 1 inch goes into the fittings at each end.