We are just under a month away and we are in full swing getting ready for the NEAT! We will have some great deals this year so stop by and see us and say hi.

Wow, 5 months have gone by since my last blog, where did the time go? So we are getting back up on the horse and going to finish the race! I finally have the pictures I promised of the new system:

http://i440.photobucket.com/albums/q...Pilot-II-1.jpg

The components are:

IRNet Programmer - top
IRNet Router - center
CPII Computer Module - left
CPII Vertical Sensor - lower left
CPII Main Sensor - lower right

We are getting ready to start flight testing again. You can bet that the next half way warm day we will be out at the field. Until then...........

Flight testing is going great!!! Initial testing has been on a high powered "Razor" with GPS clocked speeds in excess of 90 MPH. We have switched over to a small electric 3D aircraft this week. We are dialing in on the vertical hover and knife edge modes. Next aircraft will be my Ultra Stick with a Saito 180. We will put it through the paces these next few weeks then switch back to an electric so we can hopefully demo it at NEAT next month.