Comments (1)
Add Comment
I have never done a build log or written instructions. Its harder than it looks....
I stole alot of the instructions from the other thread, so thanks for letting me steal your stuff.
Anyways, hope this helps consolidate all the great information on the great plane.
Cut out servo bays. Remove foam all the way down to the skin on the top of the wing so the servo sits as deep into the bottom of the wing as possible. This will allow the servo horn to protrude as little as possible under the wing.
There is a black piece of material that forms the void for the servo wires when removed. Do not cut through the skin deeply in that area to avoid cutting into black material, so that it will retain its strength and not be cut which will make it harder to pull out if it breaks. If it does not easily come out, do not pry or force it. It may be easier to free the material after the hole for the servo wires is drilled....Continue Reading
I stole alot of the instructions from the other thread, so thanks for letting me steal your stuff.Anyways, hope this helps consolidate all the great information on the great plane.
Cut out servo bays. Remove foam all the way down to the skin on the top of the wing so the servo sits as deep into the bottom of the wing as possible. This will allow the servo horn to protrude as little as possible under the wing.
There is a black piece of material that forms the void for the servo wires when removed. Do not cut through the skin deeply in that area to avoid cutting into black material, so that it will retain its strength and not be cut which will make it harder to pull out if it breaks. If it does not easily come out, do not pry or force it. It may be easier to free the material after the hole for the servo wires is drilled....Continue Reading
