Posted by old4570 | Today @ 07:59 AM | 8 Views
Mods to my Whip .

Was it maybe 15 months ago I got the Whip ? Anyhow I have a bad back and the whip was medicinal ( get me out and being more active ) . At one time my back was so bad I could barely walk 100 meters . Now I can walk a few Kilometres to a local park and throw the whip around for 30 minutes to 60 minutes and walk back home and not be in brutal pain . ( A little sore perhaps )

Anyhow , early on I came to the conclusion I needed a launch peg to make life easier on me ( less painful ) . Already I was noticing a lot of surface stretch marks on the wing . And I thought without strengthening I would surely rip the wing apart if I put in a lunch peg .

Modified wing :
I removed the plastic hardware , the centre of the wing was glasses ( lightest glass from hobbyking ) . I also glassed the tip I wanted to put the launch peg on . Glassing also was used to secure the carbon rods in the middle of the wing . ( Mine were lose and there was a lot of centre flex )
After glassing I used laminating film ( 0.04mm = lets get that right ) . I now had a really strong and much stiffer wing than before . To counter the added weight the plastic wing hardware was given the heave ho and I cut up an ice cream container to make some pads for the wing screws .
I also added a counter weight on the opposite wing tip ( not sure this was needed )
Now I had a wing I was sure would handle peg launching .

POD :
Strengthening the wing just meant that energy would...Continue Reading
Posted by phyngineer | Today @ 07:14 AM | 15 Views
The reporter learned from the provincial traffic police corps highway detachment that the provincial traffic police corps highway detachment took the lead in enabling drone air inspections in the jurisdiction, and the drones focused on capturing traffic violations such as emergency lane parking and big car occupation. This is the first time that the high-speed traffic police department of our province has enabled drones to participate in highway traffic management.
UAV inspection duty is mainly used for aerial photography to observe road traffic congestion and capture traffic violations. According to the police who used the professional training of the UAV in the early stage, in the scope of the radiation coverage of the drone, it is possible to find where to shoot, and all kinds of violations of traffic rules and road safety can not escape its law. The trajectory of all vehicles and the number plate of the vehicle can be taken very clearly. For some motor vehicles that do not follow the prescribed lanes, illegal lanes for illegal lanes, and emergency lanes, they can be captured, providing strong evidence for the traffic police department to be punished according to law; and capturing and exposing some illegal activities such as retrograde vehicles. Elimination of blind spots in road enforcement.
In addition to the use of drones to capture traffic violations such as emergency lanes, the most important thing is to use drones to view road traffic congestion and traffic accident scenes, to provide timely and accurate information support for slow blocking and smooth operation. In the event of a traffic accident causing congestion, the traffic police can not arrive at the first time, the drone first arrives at the incident, and the scene is transmitted to the rear for the first time, according to the actual situation, the next step is given, and at the same time, The traffic police will have a more comprehensive understanding of the traffic accident scene and provide a basis for accurately handling the accident.
Posted by Bill M - RC | Today @ 06:00 AM | 22 Views
Hi fellow rc pilots & rc enthusiasts

Happymodel 1102 8500kv Brushless Motors review. These Happymodel EX1102 8500kv brushless motors are one of the lightest motors around, well crafted & designed with double bearings & good dynamic balance.

You can get these Happymodel Brushless motors in UK here: https://amzn.to/2NvcgKj

You can get these Happymodel Brushless motors Internationally here: http://bit.ly/2lXhrWE

RC CLEARANCE SALE on here: http://bit.ly/2mpFKgd


Happymodel 1102 8500kv Brushless Motors review (5 min 49 sec)

Posted by Hobby Details | Yesterday @ 09:14 PM | 105 Views
Premium 12 in 1 Magnetic & Lock Screwdriver Set

Hex1.5/2.0/2.5/3.0mm
Box4.0/5.5/7.0/8.0 mm
Phillips 4.0+/5.0+
Flat 4.0-/5.0-

Titanium Tips(6.35mm/1/4)

1set
Wholesale Price please PM or contact me at: [email protected]
Posted by DoubleEagle | Yesterday @ 07:54 PM | 129 Views
Giant 1/7 Scale RC Land Rover Defender 110. Hobby grade, 2 speed, hardbody! (11 min 40 sec)


Great review by Tomley RC Garage
Posted by old4570 | Yesterday @ 07:50 PM | 149 Views
no more

It's now a RC glider ..

https://www.banggood.com/100cm-Wings..._warehouse=USA

It's blowing a Northerly Gale at the moment ..

But early this morning I took it into the back yard for a quick and dirty CG check with a Zippy 350 .

It glided across the back yard like a dream and smacked the brick wall

I havent glued the motor , so no damage .

But looks very promising .

A-team Hannibal (0 min 15 sec)

Posted by JohnVH | Yesterday @ 05:28 PM | 172 Views
Flight two on this twin EDF Fighter!
Freewing SU-35 FLIGHT TWO Twin 70mm EDF Thrust Vectoring Jet (5 min 48 sec)

Posted by QuadifyRC.com | Yesterday @ 05:06 PM | 161 Views
I've recently completed my review of the happymodel larva-x and have also covered off
  • Setup
  • Custom PID tune
  • Custom filters
  • Durability tests
  • Comparison of onboard DVR to goggle DVR

It's a great little quad but there are some durability question marks around the motors in particular and as you can see in my review, Happymodel are already working on a response. That aside it's a great value, fast, nimble and very quiet ultra light micro 'toothphick' that is well suited to park flying and other environments.

Full review is here:

https://www.quadifyrc.com/reviews/happymodel-larva-x-review-setup-pids



.

Posted by aopen3434 | Yesterday @ 10:55 AM | 1,072 Views
X8-RDM ENCODER BRUSHLESS GEARED SERVO MOTOR






X8 - RDM encoder Brushless geared SERVO Motor 32bit control power unit
This is NEW Driver board for BGC motor RMD-S and RMD-L, ONLY Difference is installed a different driver board with RS-485 industrial communication used for robot and other Automation. This motor is best for servo gimbals, turntables, robots. The motor have the same size and fixed holes, RMD-S and RMD-L servo motors are compatible with or BGC driver board.
RMD-S and RMD-L are based on RS-485 industrial communication ,the advantage is anti-jamming ability. (suitable for long distance transmission)and also the motor speed higher used for robot and

...Continue Reading
Posted by Master splinter | Yesterday @ 04:15 AM | 1,203 Views
Im looking to purchase the VQ Beechcraft Baron 69″ Wingspan EP/GP Civilian version pm me if you have one to sell
Posted by rc38joe | Yesterday @ 02:49 AM | 1,233 Views
Hiya Fellow Flyers:

The Annual Omahawks R/C Auction date has been set and the Hall is reserved for our next auction on Oct 13, 2019..

The Omahawks R/C Club is hosting a R/C Auction in Omaha (See attachment) @ Hobby Town Hobby Plex located at 10200 Scott Circle, Omaha, NE 68122 on Sunday October 13th, 2019.

Doors open at 7:00 AM CST, Auction starts promptly at 10:00 AM.

Information will be posted @ Clubs web site at: http://omahawks.org/ , check right navigational column.

Question contact Kevin Hyde at 402-670-8320

Food and Refreshments offer for sale, Admission is $5 kids under 14 are free.
Posted by UnknownForces RC | Yesterday @ 02:00 AM | 1,243 Views
Desert buggy design body panels made of clear polycarbonate.
Posted by UnknownForces RC | Yesterday @ 01:24 AM | 1,242 Views
Driveline parts (drive shafts and cups, gears) and turnbuckles made of chrome-moly steel.
Posted by UnknownForces RC | Yesterday @ 01:17 AM | 1,261 Views
Very smooth and quiet running transmission with longitudinally mounted motor. Completely encapsulated, no exposed gears. The UFRC Growler GX1 is almost as quiet as a small 1/10th scale car! This is particularly due to the spiral cut bevel gears and helical cut spur gears. The positive connection of the gears on the intermediate shaft is designed as a profiled shaft based on the cycloids of higher level.
Posted by Jumper factory | Sep 17, 2019 @ 10:08 PM | 1,288 Views
T16 can control the helicopter
Posted by Hobby Details | Sep 17, 2019 @ 09:36 PM | 1,291 Views
Premium Allen Wrench Set - Black Gold 4pcs Big Handle
DTT02022A Hex1.5 x 182mm
DTT02022B Hex2.0 x 182mm
DTT02022C Hex2.5 x 182mm
DTT02022D Hex3.0 x 182mm
Titanium Tips
4pcs/set
Dia 20mm Handle, bigger than usual dia 18mm handle
Optional to change to with SAE(Inch) Hex or Ball Head Tips, same price
Wholesale Price please PM or contact me at: [email protected]
Posted by old4570 | Sep 17, 2019 @ 09:30 PM | 1,338 Views
https://www.banggood.com/custlink/DmvDLuaEWD = HappyModel 0802

Just came in the post .. Like 60 minutes ago .

1-2s , And it is sooo cute !

The 1103 pictured with it does not run , I have ordered another 1103 ( hope it gets here soon ) , the 0802 got here rather quickly ( Thanks BG ) .
I just got a 1s capable ESC so am looking forward to some testing ..
Just need some AAA carriers so I can mod my tachometer from button cell to 2xAAA .. ( Especially since I already butchered the Tach )

Wonder if this little motor will push the 450x micro wing ?
Some interesting tests to look forward too .. ( yes )

Super tiny only 1.9g
Double E-clip design, prevent Motor bell to flying off

Brand name: Happymodel
Item name: SE0802 1-2S brushless motor
KV: 16000KV, 19000KV 22000KV (option)
Shaft Diameter: 1.0mm
Configuration: 9N12P
Stator Diameter: 8mm
Stator Length: 2mm
Motor Dimension(Dia.*Len): Φ10.5mm*14.9mm
Terminals: JST1.25mm
No.of Cells(Lipo): 1-2S
Wire length(include connector): 40mm