Comments (0)
Add Comment
-
Views: 424
BO Mini Hex and the DRQ250, both sold to happy clients -
Views: 451
The most expensive Blackout Mini H build I've done. Cost about 1250 in parts alone! Has T-Motor, OP Revolution, EZUhf Diversity RX, etc etc. Damn nice build for a happy guy. Please don't crash it... to badly =) -
Views: 374
MXP230 I recently sold, flies fantastic -
Views: 400
My most recent build. A Blackout Mini H. Just maidened it and the thing is super fast on HQ Props 5x4 and 4s batteries -
Views: 362
Here is the new BO Mini H I just built alongside its bigger brother the BO Mini Hex. Really tempted to keep both -
Views: 371
-
Views: 390
-
Views: 364
-
Views: 444
-
Views: 430
-
Views: 426
-
Views: 408
-
Views: 403
-
Views: 437
Side fed cloverleaf, my favorite antenna as it allows me to pretty much embed the whole thing in the foam. Really makes it low profile -
Views: 460
Wire nest! Had to make the lid bulge up a bit to accommodate all the servo plugs. The RVOSD is on the vibration mount. I had to cut some of the foam from the bottom and it still wasn't enough room. -
Views: 437
Toughbay really makes the center section of the Zii stronger. No more flex!
-
Views: 496
In case you dont know, the little symbol on the left is the Rebel logo from Star Wars -
Views: 414
Back side, has a surprise when a light is shined on it -
Views: 406
I used black and red reflective vinyl and it turned out better than I ever thought it would. It really looks awesome under a light. I am going to go back in and remove some of the carbon vinyl and replace with this reflective stuff -
Views: 397
Used a strip of reflective vinyl to cover up where the top and bottom carbon vinyl meet -
Views: 423
The red rebel logo is begging for reflective vinyl -
Views: 399
1.3ghz Fan antenna from Hugo at TrueRC Canada -
Views: 409
pitot tube from the Ruby -
Views: 412
Gopro + SC2000 Cam