KKDDMM's blog View Details
Posted by KKDDMM | Aug 20, 2016 @ 05:15 AM | 13,152 Views
So,I will go to ALIGN's head-office,and will take a photo of entrance.
Posted by KKDDMM | Nov 13, 2014 @ 10:00 AM | 15,433 Views
So,I want to check happy-heli-shops around Torrance.
Please tell me nice-shops.

Posted by KKDDMM | Jan 25, 2014 @ 02:24 AM | 15,971 Views
I found at shop today.
Posted by KKDDMM | Sep 22, 2013 @ 08:41 PM | 16,864 Views
Posted by KKDDMM | Jan 18, 2013 @ 10:05 PM | 20,325 Views
My friend told me a new product "SYMA F3".
I want to get Her,and want to check Her,but can not buy now.
It is a pre-information perhaps.
I want to buy Her before I go back to Japan......
Posted by KKDDMM | Jan 07, 2013 @ 12:42 AM | 20,425 Views
Today I found out "HUANQI 868" at TAOBAO.

It seems like (F47+260A(V911)+WALKERA)/3......

The servos is independent type with 5 lines as F47.
The head is normally Bell-head as 260A(V911).
The TX is able to change mode by upside-down as 260A.
The battery has WALKERA type connector.

But...little heavy...53g...ahh

I hope She has no mixing as F47(L6030).
Posted by KKDDMM | Jan 06, 2013 @ 02:34 AM | 21,685 Views
Today I checked my HT8 again and again and again.
Also the servos move eccentrically when motor start moving.
Finally I tried D/R very low,so I can hover my V922 and FBL100 with HT8(Ver1.1).

I can never thank pedrojlucas enough.

And I'm sorry,I told a mistake information.
Posted by KKDDMM | Jan 05, 2013 @ 10:50 AM | 20,548 Views
I'm very sorry.

I tried again HT8(Ver1.1) with 9X to hover V922/FBL100.
And I succeeded!

I changed D/R very low,so I succeeded!

I'm sorry,and very thanks to "pedrojlucas".
Thank you very much!

Please forget under article,please.
I tried HT8 with 9X/2801/DEVO10/DX6i to bind V922,but didn't succeed.
But my friend "kaycube7" succeeded bind with 2801,and "pedrojlucas" succeeded too!



Today,I checked my HT8's version,it is 2012.06.25(Ver1.1).
My friend's is 2012.05.13

Why? Newer can not use,Older can use?

It means HiSKY made a mistake UP-gread ???

So be careful,if you want use HT8 with 9X,do not buy 2012.06.25(Ver1.1).
You should better buy 2012.05.13.
I think.
Posted by KKDDMM | Jan 04, 2013 @ 06:42 AM | 22,187 Views
I bought lots of helis in 2012.
Helis under consideration for awards are......

Ladybird V1(鉄板)
Ladybird V2(安い鉄板)
9968<イロコイス...Continue Reading
Posted by KKDDMM | Dec 20, 2012 @ 11:43 PM | 22,268 Views
I got HT8,because I wish to bind to V922 using with 2801PRO or other TX.
I tried it with 2801PRO/DEVO10/9X/DX6i.

And I understood HT8 can bind to V922 with those TX,but can not fly.
Servos does not move smooth.
And when motor be turning,every servos start moving messily.

I can not use HT8 with those TX.
and I don't have FUTABA and JR's TX.

I was disappointed about HT8.
Posted by KKDDMM | Dec 14, 2012 @ 02:05 PM | 22,817 Views
I've got #9968 today.
She is a new heli by Great Wall.
A little large than #9958,#9998,almost same as H105B(Hubsan).
And Her BODY is beautiful as H105B.
And She can fly well than H105B.
AND! She can bind with 9X!!!

I think ...... Great Wall makes a big hit!!!
Everyone will like Her,who tried Her,I think.

I'll up more photos tomorrow.
Posted by KKDDMM | Dec 09, 2012 @ 05:52 AM | 29,267 Views
I will report them,after back home.
I'm back home,so let's start the review.

1)The TX of V912 is very good for normal V911 as 9X.
2)The RX of V922 is different from the "sample"

I tried flying normal V911 with TX of V912.
The TX of V912 is better than the TX of V911.
The best choice is 9X.
But for normal V911,TX of V912 is enough to play,I think.
But if you make a mod(ex. barless or other),you should choice 9X.

I checked V922.
I found the version number is changed.
The RX of shop-sample's version is V1.3.
My V922's version is V1.4.
So now I don't know,V922 is the same thing as FBL100 or not...

I'll check my V922 can bind to FBL100's TX? or not?

I think,this V922 is a second CP-heli for beginner.
Can not change pitch-curve,so very difficult for beginner,I think.

see next page,more photos
Posted by KKDDMM | Dec 04, 2012 @ 09:26 AM | 20,441 Views
I bought lot's of clones.
I'm really crazy,I know...

Therefore, I would like to introduce these three helicopters to you.
I recommend these helicopters to you!

H105B(very beautiful)
I changed my opinion,I don't recommend F47(F47(The best for practice flying barless))
I changed my opinion,I don't recommend L6030(L6030(There is originality))

Now, buy these three sets wholly!

At first!
You should better get V911 or Y911!
And don't forget 9X!

################################################## ##
(edit at 2012-12-21)

I found,F47 and L6030 has an eccentric mixing of rudder today.
If you operate rudder,then Her cancel elevator,so can not fly bank-turn(tilted-turn).
F47 cancel aileron too,L6030 cancel only elevator.

So I changed my opinion,I don't recommend this two.
Posted by KKDDMM | Nov 30, 2012 @ 07:50 AM | 23,992 Views
I went to "Castle" today,for checking a sample of V922 again.
And I tried simple-3D-mode,I could fly up-side-down hover.
(I can not do 3D)
And asked a few questions to storekeeper about V922 (and FBL100).
And checked myself.

So I knew......
1) Between V922 and FBL100,the heli is the SAME things.(storekeeper told)
2) The NEW TX of V922 has only 2 switch at each shoulder,
Left is simple-3D-mode,right is only motor kill.(each SW has 2 positions)
During in flight,you can operate only 2 switch,at each shoulder.
3) Perfection mode-free(1-4).
4) In set-up-mode you can only change,D/R(high or low),mode(1-4).
5) The NEW TX has no model-memory,has no EXP-curve,perhaps.
6) Perhaps RTF of V922 is cheaper about 200RMB than FBL100.(storekeeper told)
7) If you can fly CP-heli,you should better choice TX of FBL100,I think,
because TX of V922 has no EXP,no Flight-mode,no model-memory.

I cheched a sample,so maybe be different with production model.
Posted by KKDDMM | Nov 29, 2012 @ 08:48 PM | 20,605 Views
A NEW Heli came,She is not a clone of V911,a little large.
The TX is looks like F47's TX,but not same size,and not compatible.
And can not bind with 9X......

She is better than FD1098,can fly well than F47.
(I hope I can find a compatible TX,it can bind with F47.)
Posted by KKDDMM | Nov 24, 2012 @ 09:57 PM | 22,911 Views
I went to "Castle of Toys" yesterday.
I was very lucky to meet V922's sample.
I checked NEW TX and V922,and tried flight.(only hover (I can't do 3D))
The NEW TX is better than old TX,big enough for control.
And storekeeper said,this NEW 6ch TX can not bind other old WL-TOY's products,NEW 4ch TX can bind old products.
The sample TX had a print "4 channel" and sample heli had a canopy of FLB100......
He said V922 will come at Dec.20,perhaps.
Posted by KKDDMM | Nov 23, 2012 @ 10:30 AM | 21,647 Views
I've got a NEW clone today.
She is almost same as V911,except battery and 2.4G system,She can not bind to 9X.
So I was disappointed......

She can fry well than SH-6032,6035,and F47.
But can not use 9X,so D911 is better than YD-917,I think.

see next page more photos.
Posted by KKDDMM | Nov 20, 2012 @ 11:21 AM | 21,406 Views
I ordered Her yesterday,and I've got Her TODAY!How fast!
She is not a copy of V911.
She is a Franken of 270A(main blade),MINI-CP(rudder),and more.
I like her servos,not on boad,and I like her slim canopy.
She flies very stable.

but...not enough slant of swashplate,so can not turn with bank.
I modded bell bar light,and changed linkage of swash to outside of servo horn,
but not enough......

and TX of RTF is better than TX of V911,but not very good as 9X.
So I must look for compatible TX,same as 9X.

Do you know fine TX,it can bind to F47(F45)???

see next page,more photos......
Posted by KKDDMM | Nov 12, 2012 @ 10:59 AM | 21,767 Views
I got a NEW heli today.
Her name is "No.9039" DEFATOYS made.
She can bind to 9X,Her TX can baind to V911,compatible with V911 !!!
And Her TX is better than V911's TX,I think.
But She isn't stable......perhaps the weight of bell bar is too heavy.
I'll try change the bell bar for lightweight bar next time.

So......Can I call Her "D911" ???

See next page,more photos.