Posted by ljones7533 | Yesterday @ 11:58 PM | 53 Views
heres my edge 540 with a 20 dle on it will soon have the cowling mounted and i have a 3 bladed prop and spinner on the way
Posted by kopterheld | Yesterday @ 11:40 PM | 62 Views

Diatone GTB339 Cube:
Banggood Coupon: AFFBG10

Very good and fast 3S 3 inch drone which is very light with the Runcam Nano 2 camera and TBS Pro32 Nano VTX

or the Diatone GTB229 Cube 8500KV 2S Version 2.5inch drone
from Banggood with Coupon: BGGTB
Very good and fast 2S 2.5 inch drone which weighs only 43 grams with a Runcam Nano 2 camera and TBS Pro32 Nano VTX

- lighter 3 inch FPV racer
- Good Runcam Nano 2 camera
- powerfull VTX TBS Nano Pro 32 25-400mW
- very good motor 1105
- F4 Board 3-4S 12A ESC's
- external receiver such as R-XSR, CrossFire

- Camera like Runcam Racer Nano or Foxeer Predator 4 Nano would be even better
- Video antenna only linear
- Motors a bit too fast with 5500KV for 3S battery

Video 1 - Diatone GTB339 Cube 3 inch FPV Micro Racer
Diatone GTB339 Cube 3 Zoll FPV Micro Racer (6 min 51 sec)

Suitable batteries:
BETAFPV 300mAh 3S 45C -
GNB 300mAh 3S 45C -
GNB 450MAH 2S 80C -
Tattu 450mAh 3S 75C
Banggood -
Amazon -

GNB 300mAh 3S 30C 
Banggood -
Amazon -

Happymodel 300mAh 3S 30C 
Banggood -
Amazon -

Turnigy Nano-Tech 300mAh 3S 45C -
HobbyKing -

HQProp T3X2 - Banggood - http://bit....Continue Reading
Posted by ronaldopn | Yesterday @ 07:26 PM | 110 Views
This link is actually for me to get back to this awesome post but feel free to check if you want to go deeper on power system calculations.
Warning: numbers and formulas involved, not for the faint hearted
Posted by Blaze0021 | Yesterday @ 07:02 PM | 128 Views
This is the 44th and final Test Flight of my Arrows RC F4U-4 Corsair 1100mm Warbird, modified for 4S power.

Arrows RC F4U-4 Corsair 1100mm Warbird Golden Hour 4S Test Flight #44 (5 min 36 sec)

Enjoy the lack of extra sounds other than the ambient noise, the voice of my Spektrum DX8 (G2), and the whistle of a precisely balanced 4-blade prop on 4S with the airframe whoosh of a Corsair.

I will apologize in advance as I feel like this flight was more subdued and restricted than what I normally would perform. I almost forgot how difficult it was to use the Action Cam iPhone Headmount... having the weight of an iPhone 7 strapped to your forehead and guessing what your iPhone is actually capturing during the flight while performing maneuvers can be awkward and a bit of a challenge.

The stock 40-Amp ESC has been replaced with a ZTW Mantis 65-Amp ESC with 5-Amp SBEC, and has been relocated from the tight air-restricting box that the original 40-Amp ESC was originally placed within the nose, to the interior compartment for increased air circulation. The original ESC "box" location has been left open for adequate ventilation to the interior compartment, with only the motor/ESC wires to channel through it. The plastic dummy radial faceplate cowl has been drilled with additional ventilation holes for increased airflow and cooling to the motor and interior compartment leading to the upgraded ESC.

The stock 11.5x8 4-blade prop has been replaced with a...Continue Reading
Posted by alex_nikiforov | Yesterday @ 01:38 PM | 186 Views
Eachine TX805S - 1600mW? Banggood (4 min 51 sec)

+ convenient form factor
+ cooling radiator
+ stable at 25mW
+ smart audio
+ pit mode

- low power values from declared
- very hot at maximum power

Eachine TX805S
Eachine TX805
ImmersionRC RF Power Meter v2
Posted by unboxingexp | Yesterday @ 11:56 AM | 200 Views
Posted by fastmax | Yesterday @ 09:35 AM | 275 Views
Let the new build begin. I hear the Eachine Tyro machines are a pretty good value in a 5 inch kit, so figured I'd build one and see for myself.

They spec out fairly nicely, and at the Tyro109's current price of $109 in the USA warehouse if it performs half decent it'll be hard to beat for a budget 5 inch quad.

Package Includes:
1 x 210mm frame kit
2 x 2206 2400KV brushless motor CW
2 x 2206 2400KV brushless motor CCW
1 x 4 IN 1 30A BLHeli_S ESC
1 x Customized F4 flight controller
1 x Caddx Turbo Eos2 1200tvl
1 x XF5804 5.8G 40CH 0mw/25mw/200mw/600mw switchable VTX
2 x Battery strap
1x Antenna
2x 5040 four-blade propeller CW
2 x 5040 four-blade propeller CCW

Will post updates as the build progresses.
Posted by JimboPilotFL | Yesterday @ 09:07 AM | 254 Views
I have published a couple of build logs on RCG and if you would like to see them they are here.

Great Planes Trainer .60 - aka Maule Sport.

Top Flite Cessna 182 kit build.

I also have a YouTube Channel with many hat cam videos and a few onboard flights.
Posted by GBLynden | Yesterday @ 04:15 AM | 292 Views
This is my go to jet when I am concerned about flying in low light!

Freewing BAe Hawk T1 70mm EDF Jet Flight At Dusk (4 min 13 sec)

Posted by Reckless_fpv | Yesterday @ 12:13 AM | 307 Views
600 subs!! 🍻 Thanks everyone!! Get ready for the edge of your seat with this one. Not your every day windmill rip!! Full edit has some insane ninja manoeuvres!!
Epic Windmill Dance FPV Freestyle 600 subscriber celebration!! (9 min 10 sec)

Posted by GroundControlRC | Aug 24, 2019 @ 09:58 PM | 323 Views

Here is a link to the Video:

Actually, I think I'm performing these DustOff Flights before the dust even settles ;-)
Too much fun!
I wanted to switch out the 3020 Prop I've been using and install a 3025 Prop just to see if it's any faster ;-)
Like it's not already fast enough right?

Here is a link to the Control Surface Deflections I use:

Here is a link to the Project Conclusion video:

Here is a link to the Updated Plans & Templates video:

Here is a link to the Chuck Glider Conversion Playlist:

Here are links to all the components we used in this project:

48cm Big Size Hand Launch Throwing Aircraft Airplane Glider DIY Inertial Foam EPP

DYS BE1104 1104 Brushless Motor 5400KV 6500KV 7000KV 2-3S for 100 120 150 RC Drone FPV Racing Multi Rotor - 7000KV

2 Pairs Gemfan 3025 PC Propeller CW/CCW For 1104 Motor 120 150 160 RC Drone FPV Racing Multi Rotor

2.4G 4CH Micro Low Voltage DSM2 DSMX Compatible Receiver Built-in Brushed ESC

EMAX Babyhawk 85mm FPV Racing Drone Spare Part 2S 7.4V 300mAh 35c Lipo

HobbyKing™ HK-5320S Ultra-Micro Digital Servo 0.075kg / 0.09sec / 1.7g

Turnigy MultiStar Race Spec 7A BLHeli-S ESC 1~2s (Opto)

Pololu Adjustable Step-Up/Step-Down Voltage Regulator S7V8A

Turbowing 5.8G 48CH 25mw Transmitter 700TVL 120 Degree Wide Angle Wireless FPV Camera NTSC - Copper Antenna

See you in the Air!

Build, Fly, Crash, Repair, Rinse & Repeat!

See Us On Youtube | Patreon | RCGroups
Posted by marksp | Aug 24, 2019 @ 08:59 PM | 360 Views
Decided to replace dead stick crash of my Valiant 30cc with the new Timber 110. Looks to be a higher performing newer design of a high wing bush plane that I can use most of my same components :-)

- VVRC40
- Hitec 5645MG ailerons/flaps/elevators
- Hitec 7956 rudder
- Tail dragger RC servo extensions
- Jeti EX R10 REX Assist
- Tech Aero IBEC
- Tru-turn 3” alum spinner
- XCub sprung gear
- XCub tail gear
- Dubru 6” tundra tires
- QuickFire fuel filter
Posted by Bill M - RC | Aug 24, 2019 @ 07:32 PM | 344 Views
Hi fellow rc pilots & rc enthusiasts

Skyzone SKY02X FPV Goggles review. This SKYZONE SKY02X 5.8Ghz 48CH Diversity FPV Goggles Support 2D/3D HDMI Head Tracking With Fan DVR Front Camera For RC Racing Drone review includes unboxing, overview, features, functions & tests. I also share this with other fpv rc pilots to get their impression and opinion of this Skyzone 02X FPV headset.

You can get these SKYZONE SKY02X 5.8Ghz 48CH Diversity FPV Goggles Support 2D/3D HDMI Head Tracking With Fan DVR Front Camera For RC Racing Drone here:

You can get the SKYZONE SKY02C 5.8Ghz 48CH Diversity FPV Goggles Support DVR HDMI With Head Tracker Fan For RC Racing Drone here:

Skyzone SKY02X FPV Goggles review. 2D 3D 5.8ghz Diversity FPV Goggles (23 min 44 sec)

Posted by ronaldopn | Aug 24, 2019 @ 04:43 PM | 426 Views
For those who fly larger electrics this may be helpful. Swapping batteries can be annoying if you have to deal with those canopy thumb screws everytime. I always replace these screws with a aluminum latch. This is not an issue if you fly gas since you can refuel without taking the canopy off.
Here is the step by step.

EDIT: the lever is made of a very thin wire and broke after using a few times so I removed it and drilled a hole on the main pin to insert a 2mm pushrod. I recommend doing this mod or using the heavy duty latch shown in the picture.

IMG 1973 (0 min 13 sec)
...Continue Reading
Posted by CGordon | Aug 24, 2019 @ 03:41 PM | 386 Views
Remember those potholder looms for kids? It gave me an idea...

This is another application I have not seen - an all-carbon truss spar. Using wetted carbon tow (12K in this case), I wove a truss pattern though a set of brads. The idea (Pratt or Warren without verticals truss styles anyway) is to be able to slide ribs into a finished spar unit.

For fun I tried some different patterns with string (second photo). I notice you can take an extra round on the perimeter if you need more thickness.

In practice I found the tension tends to flatten the tow, and this isn't ideal since you'd like more of a round or square section. Despite this the test is very sturdy and certainly benefits from not having any glued joints.

I'm thinking about building a fuselage side like this for my 24" Telemaster. I could use my thickness sander to ensure a flat, uniform surface and make the carbon closer to a square profile.
Posted by Tazkiller85 | Aug 24, 2019 @ 05:08 AM | 583 Views
Yep Les Amis,
Multiprotocol Mix Music Party ! lol ... J'ai enfin reçu ma nouvelle Jumper T8SG V2 PLUS... J'étais déjà très content de ma V1 pour le multiprotocole et son faible encombrement, mais là, je suis aux anges grâce à la V2 PLUS. La finition globale est au rendez vous bien sur, mais l'ajout de Gimball Hall fait toute la différence au niveau du confort et de la précision du pilotage ! Après la V1 puis la V2, la V2 PLUS apporte vraiment quelque chose qui la rend plus sérieuse en face de la concurrence . Le Multiprotocole, les Gimball Hall, sa simplicité, les Voix/mp3 et sa finition carbone raviront certainement plus d'un pilote débutant ou initié. Bon Film à Tous et Félicitations aux GAGNANTS du concours

Jumper T8SG V.2 Plus Carbone - Review Test Astuces - Résultats Concours DJI ! (34 min 3 sec)

NOTATAZ : 18/20 Belle Evolution Mr Jumper !

- Si Vous voulez soutenir la chaîne avec un don :

Les produits présentés sont visibles ici (en cliquant sur ces liens vous soutenez ma chaîne) Merci à vous :

- Jumper T8SG V2.0 Plus Carbon ( COUPON aff7off ) 100€ :
- Batterie 2S pour Jumper T8SG :
- Jumper T8SG accessoires :
- Antenne longue :
- Adaptateur Antenne longue :
- Lien vers Installation Module VOIX :
- Vidéo Set Up Jumper :
- Notice : http://...Continue Reading