Archive for August, 2012
-
Views: 118
The first job was to seal the end of the wing joiner and then glue into place, the wing roots had to be re cut to form the required dihedral -
Views: 94
The Vee tail is then joined together and I reinforced the joint with GRP -
Views: 94
Whilst using GRP I also took the opportunity to strengthen the inner nose -
Views: 85
Cutting into the wing root to fit a hard blocks through which the wing fixing bolts will pass through, there are four of these in total -
Views: 84
Looking down the fuse, I have shaped a ply plate into which the wing bolt nuts have been installed -
Views: 108
Due to the wing profile I had to use a slim wing servo so I chose Hobbyking, they appear to work fine on the bench! -
Views: 98
The ply skin which I initially removed was re glued into the aperture to provide a bit more strength, the servo is kept in place with double sided sticky tape -
Views: 100
I decided to use ball joints to secure the tail controls, this should reduce some slop
Comments (0)
Add Comment
