Yazz's blog View Details
Posted by Yazz | Jan 09, 2015 @ 02:57 PM | 14,029 Views
VisionAire: Stock setups

I posted stock setting for the Vision Aire at the beginning of Jan on the Horizon Hobby Web page but my answer was never approved to show up. Not sure why? Maybe these are a secret or they different depending on how sloppy the servos they put in yours..lol

My new VisionAire had these stock settings programmed in. If you have any slop in the servo with these you'll get flutter in 3D mode at 1/4 to full throttle depending on how much slop.

With a tight servos, a balanced prop and receiver that's not loose, I have flown full power on ocation without flutter 100s of times but only in quick bursts. Some planes can and some can't fly 1/2 throttle without oscillation. it's a mystery as why. So you may have to adjust it a bit. Cutting aileron and elevator 20% is fine for me flying more tight in field fun fly type flying. 3D might be a tad harder but it really only comes with hours and hours of stick time in the air or on the simulator.

To get into programming mode of this RX (mode 2).

1) Power on transmitter
2) Select 3D mode with gear switch
3) Place throttle at half stick and leave there until done programming/viewing ( lowering it back down will save and get out of programming mode)
4)Move right stick to full up elevator and full right aileron and hold.
5)Power on RX and wait 5 seconds before releasing right stick. The rx will be just amber at first and then ailerons servo will go full right and elevator will go up and 2 out the...Continue Reading
Posted by Yazz | Oct 19, 2014 @ 03:07 AM | 12,650 Views
Anybody still flying one of these? And if so anyone making kits or cutting the foam wing cores?

Mine has been in this state for many years and I think it time to restore it to it's old glory. I flew gallons of gas threw this baby. One day showing off snap rolling feet off the ground, I caught a wing tip at full speed. Yup it's what i did with fun plane... show off the high speed crazy stunts. It's going to fly again!

I heard from the designer Don today , He said Lazer works http://www.lazer-works.com/main.html cuts short kits for the Flying Machine. I need to find out what a short kit is..