Archive for August, 2012
-
Views: 137
The first job was to seal the end of the wing joiner and then glue into place, the wing roots had to be re cut to form the required dihedral -
Views: 122
The Vee tail is then joined together and I reinforced the joint with GRP -
Views: 125
Whilst using GRP I also took the opportunity to strengthen the inner nose -
Views: 101
Cutting into the wing root to fit a hard blocks through which the wing fixing bolts will pass through, there are four of these in total -
Views: 107
Looking down the fuse, I have shaped a ply plate into which the wing bolt nuts have been installed -
Views: 139
Due to the wing profile I had to use a slim wing servo so I chose Hobbyking, they appear to work fine on the bench! -
Views: 127
The ply skin which I initially removed was re glued into the aperture to provide a bit more strength, the servo is kept in place with double sided sticky tape -
Views: 128
I decided to use ball joints to secure the tail controls, this should reduce some slop
Comments (0)
Add Comment
