Thread starter's only
1 esc (bec type) 1 motor with bec disabled for seperate battery pack
1esc with bec, no rx battery
1esc with bec two motors
1 main battery two esc's
2 batteries parrallel two esc's
mechanical esc 1 motor
1 battery 2 esc's with disabled bec system, using seperate power source for Rx, and mixer for control of the two esc's
modified Diagram #2 (showing my components)
Basic smoke wiring
Upper left is the smoke and sound units.
Bottom view of the cabin. Th eblack box on the left is the smoke unit with a small servo to move the white flapper over the fan.
Proposed Charging CCT for Tico Build.pdf
Uss Triconderoga Charging.pdf
Rudders work together
Rudders working opposite
12V springer with charge jacks
The copper PCB and image on the transparency.
The image has been transferred from the transparency to the copper PCB.
Etching in progress.
Etching complete. Next is to remove the toner mask and drill the holes.
Toner mask removed.
Artwork for the component side.
Solder side (etched by this method) showing drilled holes and soldered components.
Component side showing resistors and headers.
Copper foil tape from glass craft store for distribution to lighting. Will be covered with paint.
Same area now painted and masking removed.
Same area now painted.
How to make a PCB.pdf
this is a Y-lead the two esc's go into the "female" ends, with the "male" end plugging into your reciever just like a servo.
"You will buy more boat models than you can build..... FFFFFFFFT ! "
Steering and Throttle mixer for a rudderless twin screw boat.
All RCGroups content copyright © 1996 - 2015 by RCGroups.com.
Terms of Service
Mark Forums Read
Back to Top