Aircraft - Sailplanes
Thread starter's only
electrified Fling 2M
This much downthrust and about 1 degree right works well on the Fling
Battery is against the servos, hard to see in the shadow. The Electron 6 had to go behind servos to balance
Balsa bulkhead to keep things away from the outrunners spinning motor case
Lots of empty space under the canopy, Blue Cor holds the battery back against the servos
Aluminum motor mount was trimmed to push in from the back about 1mm recessed. Epoxy fillets on inside and out
air vent on both sides is just ahead of a ply former for strength
You really can't see the tape. It is under the rubber bands.
I also have a slip on power pod that actually mounts to the wing joiner when I put he wing together. The joiner slips thorugh a hole in a tab that sits between the wing halves. Then I tape the wing toghether. I have only used it a couple of times. I l
This is the layout of my electroncis
Thsi is the wing put together but not taped. This shows the the power pod mounted. The wires coming out of the wing are for my spoiler servos.
eFlite 400 outrunner ( or OS 10) on an EZ-2000 ARF.
Aiptek outside on GL
Aiplek outside on Easy Glider
Aiptek inside on GL
Aiptek outside on ROC 2000
The full 2 meters. Charlie the dog is not impressed...
The root of the problem (pun intended...)
All RCGroups content copyright © 1996 - 2015 by RCGroups.com.
Terms of Service
Mark Forums Read
Back to Top