Recent Attachments for EdrickV
MS FlightSim 2002/2004 DHC-2 Beaver on amphibious floats
Tail gear wire taped/glued to the side of the rudder following a crash or landing that damaged the stock setup.
This is my newest bird. Haven't put a prop on it yet, and some stuff still needs to be installed, but it doesn't look too bad. For an E-Starter.
Here's the landing gear itself. Wrapped first with scotch tape, then clear packing tape, and then some masking tape. Not a friction fit.
A little blurry, but there's the piece of tape that holds my landing gear in.
Side view of my Beaver. Note my "tundra" tires. :)
My Beaver and my flightbox. A black carpet and a white plane make pictures trickier to do.
My beaver. Will wait a bit before adding decals, fairings, and paint.
The stuff that doesn't come in the kit.
Dihedral former and two batteries with tape to make it easier to remove them.
All RCGroups content copyright © 1996 - 2015 by RCGroups.com.
Terms of Service
Mark Forums Read
Back to Top