Recent Attachments for NitroheadNZ
Setup I first ran. No container, watercooled turnigy 60 amp esc and a 3s battery sits horizontal behind the motor. Standard 1/10th servo also.
Don't have a welder. tried brazing with a 1.5mm tig stick but obviously the 0.5mm sheet was melding before the stick. So just made tabs and used 2-pot arildite. Has yet to break!!! Dents like you wont believe but being so thin, I just press them back out.
Don't look too close, oh yes of course i meant for the nose not to be centred... Ahahahaha (BALLS UP!!!)
First card mock-up. (keep in mind I've never built a boat before) and I didn't copy any hull designs. wish I had though :/
Not very clear but the tubing is roughly only about 20-25mm in length from memory. Just enough to come through the rubber seal at the coupler end and enough room from the impeller.
All RCGroups content copyright © 1996 - 2015 by RCGroups.com.
Terms of Service
Mark Forums Read
Back to Top