Recent Attachments for AUTO_XX
Assembled and ready, I also leave off one turnbuckle to reduce unnecessary stresses.
An essploded view of how the pieces fit together, I don't have a 4mm bolt to replace the stock one yet :(
Parts done, ready for cleaning.
The boom mount is bored the same as the motor mount but you can see the hole was off center from factory, I should have double checked...
Boring motor mount, 10mm shoulder 0.050" (fifty thousandths) for the thrust bearing race to sit against. Also boring through with a 4mm for the new bolt.
This is what the thrust bearings look like if you don't bore the mounts to seat the races. (previous post)
Chamfering the edges of Tab A a bit before pressing into Slot B will line them up and help it start in smoothly.
Using a vise or press with smooth jaws makes this easy
It isn't going anywhere...
Servo adapter with countersunk screws, perfectly centers with no guessing.
Flanged bearing moved to this side.
Motor mount with 10mm bored 0.050" deep Boom mount bored the same but also bored 8mm all the way through.
All RCGroups content copyright © 1996 - 2015 by RCGroups.com.
Terms of Service
Mark Forums Read
Back to Top