Recent Attachments for michaeldepeza
cross strap velcro so as to avoid kit slipping off skids
ensure down part of skids are at 90 degree to rods
place heli over training kit and adjust rods by sliding through cover using eyesight or measuring tape
holes are pierced through wd40 can cover being careful to ensure one set of diagonal holes are pierced higher that the other to accomodate rods. balls are thn pierced and glued on either end of rods9ensuring rod extends just a bit out of end of ball
the fibreglass rod is cut into two pieces average 3" longer than both blades fully extended span from end of one blade to other
i did the duct-tape to fix my excited dismantlement of package
my new 6ch Tx and 6ch receiver
removed PCB and Diodes
my relocated PCB
isn't she a beauty
My new lipo
this is my 9104 PCB can you show by circle what to use on 9116 PCB.
this is the 9116 PCB can you circle the stuff to remove/swap?
9116 servos side by side...could this possibly work with 9104 and 9116 swash?
9116 swashplate design allows use for two servos side by side.
servo used most of space due to swashplate design
9104 has same space or similar space i wonder if it was intended for same purposes(more evidence of possible planned but aborted 4ch intention of 9104?
9116 servos placed on both sides
All RCGroups content copyright © 1996 - 2015 by RCGroups.com.
Terms of Service
Mark Forums Read
Back to Top