Recent Attachments for molond
It even looks like the FlySky version has gold contacts.
Looks like they both have the same 'multi-length' contacts
A one inch strip was glued to the edge of the foam and was the bent along the line 5 inch from the 'front' of the strip. All the paper was left on for extra stenght (my paper is near impossible to remove)
Do not install the servos the way I did, it too all of the extra strength of three layers of foam away. It was stupid and I will not be doing that again
Sorry couldn't save only could screenshot
The ribs (to the left) nearly reach upto the intakes (maybe 50mm to spare). This is only the centre 600mm (wide) and two 600mm wide wing parts will attach to the side (1.8m total).
It may look like a lot of holes but the is a conserable amount of meat around each one (nose looks smaller than it is - about 150mm at widest point)
Pond plan2 pg2.pdf
Pond plan pg1.pdf
A slightly updated version with a prototype fuse
Just the back half so far, just need to make control surfaces and fuse body
The CAD drawing for my wing (4 leading edge pieces, 22 riblets, 4 trailing edge pieces)
All RCGroups content copyright © 1996 - 2015 by RCGroups.com.
Terms of Service
Mark Forums Read
Back to Top