Recent Attachments for awkward
Comparison between the original design and the new wing with 3 bays more each side just cause I can
Wing tips, showing the curve
Two 60" QFIIs and a Crimson 2m glider
Tail feathers and mounts. I am happy with the eight of these. The elevator has two coats of PU.
Thinking on it, there is still carbon tow to add
no. two broken ribs and the spruce spar peeled up
broken rib and rear spar
the shape hasn't changed all that much
Added Vertical Stabiliser About 30% area
CF and CA repair
Tail plane spars showing week point in balsa
tips showing the agility of Oracover
servos under cover
sure has a nice profile
well she is covered mostly using Ultracote
Unsanded rudder of Crimson compared to an ineffective rudder on the ST330 sowing size difference
My two QFII
found some lovely 0.4mm 3 ply in a local model shop. I hope this is stiff enough.
making easy parts while I wait for supplies
Photo of the tips together. Try as you may, getting the washout equal is not easy
swarm will have come from one of these hives.
I shook them into a box on the ground and as the queen is inside the box the others will wak in
not bad size. about a box of bees
found a swarm of bees from my hives at home
wing break glued in place. I might add a ply end cap
glue set. time to turn them ove for the bottom spars
there are two so I can sit all part ( spars and ribs) down in line.
the wedges taper from 1.5mm to 0.00mm
dry fitting of top spar, tube , packers and ply shear webs.
glue in the rear web only.
I will cut the trailing edge after sanding
laid up on a piece of soft board
theer are some spare ribs in that lot
Spars tapered from 10 x 3 to 4x 3 I think it is spruce
All RCGroups content copyright © 1996 - 2015 by RCGroups.com.
Terms of Service
Mark Forums Read
Back to Top