Recent Attachments for Blueshy
Different view of the Cloverleaf mounted on the wingtip.
The Turbine on my VRx and Cloverleaf on my VTx located on my starboard wingtip.
The Turbine for my VRx. (Orthogonal view.)
The turbine for my VRx. (Top view)
The turbine for my VRx. (Side view)
Squished it. Afterwords it rebounded nearly instantly back to the original wedge shape with no deformities from being squished.
A single piece broken off.
You can break them off or leave them together, they're actually all one sturdy piece in the "brick," and there are some pre-cuts made into the foam.
This is the brick of them inside.
Looks like this.
Needs a new paintjob.
When there's some wind resistance on them they push back a little further than just hanging in the air.
One continuous rubber band. Size isn't too crucial.
The first diagonal band blocks the prop from swinging back too far.
Wraps around the nut and the other side.
Motor clearance with wings - front
Motor clearance with wings - side
Motor clearance without wings
inner mounting screws, cant see the bolts but they're on the other side. You can see the two carbon rods that run along where the bolt meets the nuts.
All RCGroups content copyright © 1996 - 2015 by RCGroups.com.
Terms of Service
Mark Forums Read
Back to Top