Recent Attachments for areis81
front, with vent holes
parachute deployment system
vtx, with straw to direct airflow underneath it
CL on Vtx. the angles are ok even if they don't look so in picture
SPW on RX
CL: too close to VTx?
SPW on rx
SPW and CL
from 1 to 2 there si the inductnace on the other side. is it ok?
not smd inductance. is it ok?
panorama: 3s input to the board, 3.3 regulator to feed the txm1 and filtered 12V to feed osd and cam...
bottom view (guys, really, don't laugh, it's my very first printed circuit i make all by myself!!! :-)
the crappi LC and voltage regulating board....
rp8d1, no jumped chip....
rp8d1 but... no jumped chip???????
any contact that should not be there on the RF module pins out? center is signal, others are ground...
soldering of the sma plug. here no undesired bridges of soldering, i'm sure
lateral view of module with jumpers between the pins between rf module and pcb
upper view of module ans sma plug
quick to check
All RCGroups content copyright © 1996 - 2015 by RCGroups.com.
Terms of Service
Mark Forums Read
Back to Top