Recent Attachments for ourbluehorizon
Twin hulled foam airboat
3 meter guppy flaps and ailerons
Aileron Bird of Time
Bird of Time aileron wing joiner
Aileron detail profilm/oracover
nose with bags of room
elevator servo set in fin
3 meter guppy with bird of time in background
BOT wing joiners001.pdf
standard servo for rudder. Micro servo for stabilator
Motror wires are supported by hardwood bar to avoid contact with spinning motor
fuselage covered in lightweight fiberglass
Firewall is 2 layers of 1/16th ply. Centre hole is cut out to allow for free rotation of circlip.
cut the groove in square brass tube longer to give more movement.
uncovered with battery, motor and esc came out at 48 ozs
These connect centre panel to outer panels. Added corner bracing to outside of boxes.
Used oracover(profilm) for first time instead of solarfilm.What a difference!
Thanks to my ever patient wife!
Motor is a 3548 from Giant Shark mounted behind 2 layers of ply which are the glassed onto fuselage. Carbon strip was buried in rear of fuselage
wires placed in early for spoilers. They would have been better in D Box!
clamps from slec were really useful
did consider a flat cenre panel but stayed with plan here.
upper lower spars are spruce with carbon tow top and bottom
didnt plan this at first but at almost nil weight gives plenty extra strength
Sandwich of 1/16th ply,carbon tow and aluminum
Fokker triplane made with 3mm depron
Baby Baron manual.pdf
Baby Baron A4 Size.pdf
wing horn from credit card
cabon fiber tube embedded in ply and balsa ribs with piano wire wing joiner wrapped in tape to give neater fit
outrunner motor inside. just enough room for power train!
light ply box. Other boxes have been made of corex.
Guppy with 2 piece wing,removeable tailplane,home made wingbags,wing is held on with elastic bands.
micro saturn servo under tailplane of servo
All RCGroups content copyright © 1996 - 2015 by RCGroups.com.
Terms of Service
Mark Forums Read
Back to Top