Recent Attachments for EzEd
At the club...
This is the original picture from the Hobby-Lobby website where I purchased it.
CG is just under 1 inch back from the red line. Red line approx 6in from leading edge of the wing.
My old wattage CAP 232 for size reference.
Should have put the cowling on for the photo.
Hyperion 4020/10 with cold beer
The battery will need to go in front of the servos
Poly-Quest 3700 20C 4S pack, 6v UBEC, Titan 80A ESC
The upper left mount point was for the glow mount. We had to re-use it and drill it slightly left.
There is not much room above the hole in the firewall which is the thrust centerline.
Make sure the outside wheel rim is the concave side..
I'll try to find another motor lying around for a size reference.
For a guy used to smaller electrics this thing is huge!
Aileron servo install. Nothing fancy or tricky here. May need servo extensions.
Nice kit. Good quality covering. Anybody want to buy a fuel tank?
At the field...
No, I do not have the cheater holes cut out. Does that really make that big of a difference?
All RCGroups content copyright © 1996 - 2015 by RCGroups.com.
Terms of Service
Mark Forums Read
Back to Top