Recent Attachments for The L
The two never flown HS-81s.
The bullet connectors. 2.4mm male gold bullets. I bought them from JustGoFly.com. Any 2.4mm female bullet connector should work.
Two Tiny-S servos. They came installed. They work perfectly, as do the two in the wings.
9x6 GWS prop.
side view of the motor mount. The nose used to be about to the middle of the bell.
The motor thrust line is not perfectly straight. I just guessed, but I think I got it right, because the model doesn't go left or right at any power level, and pulls into a nice climb at full throttle.
400XT motor and mount. Pulls about 10 amps on a 3 cell lipo with a 9x6 prop, IIRC, it gets about 16 oz of thrust and and 35 mph pitch speed. With this setup you I usually got about 20 minute flights on a 700mAh 3 lipo. (I don't know anything about th
Another bottom view.
From the back.
The black dot on the tail is a 1/4 ounce lead weight I added to get the model to balance with the motor upfront.
A small dent in the fuselage.
About a 1cm long crack in the trailing edge of the left wing directly against the fuselage. Can be easily fixed.
Small dents in the right wing
BB in wing tip. The BB is down about 4mm. It is a 3mm airsoft BB.
All RCGroups content copyright © 1996 - 2015 by RCGroups.com.
Terms of Service
Mark Forums Read
Back to Top