Recent Attachments for sayno2glo
Me and my miner friend
Fuse mold with flanges.
F5D crash. Not mine tho.
2mm thread used as a horn. small ball link from aircraft world.
servo cover from Batleth
hyperion ds09scd servos. Horns are Mpjet from ACW
The secret Neu motor
Me timing and calling for Janne. Pylon #1 at the background.
pylons and mekleth-wing
clipped wing SkaT
The avarage voltage was 1V with 130A
Tomorrow it's Christmas again when I open the new molds.
It does not look too long. Or does it?
New generation lipo fuses will look like this.
The belly is flattened to give lipos pleasant ride.
..just lot's of micro balloon epoxy
Balsa was so strong it didn't need glass..
from supercool racing propellers
Between the white lines the Mach number is over 1.
Thanks Höllein for sending the box! You see the aerodynamic wind tunnel design ;)
taken with "real digi camera" 3Mpix
taken with mobile phone ;) 2Mpix
Ariane V5 spar layup. Note that the wing is only 1.5m and the plane was about 1800g. All you can see is the curve. The right amount of carbon you have to find somewhere else.
First the carbon and rohacell was vacuum bagged. Then I cut the slot for spar caps. Also sanded the rohacell at the trailing edge down to parting plane. Ailerons has 200g/m2 carbon reinforcements.
Next bagging was with spar caps inner glass and shear web balsa on both halves. The balsa is as wide as the spar so 22mm in the middle.
Then the balsa was sanded flush with the parting boards and sealed with varnish. So when I joined the halves I put very little micro balloon epoxy to the spar and most of it squeezed out anyway.
Paint test :)
Kontronik, Hacker and Lehner etc. looks like this.
Aveox, NEU and plettenberg looks like this.
All RCGroups content copyright © 1996 - 2015 by RCGroups.com.
Terms of Service
Mark Forums Read
Back to Top