|Jan 06, 2009, 04:06 AM|
BlackStork OSD - Current sensor pinout
My heli eats more than the 50 Amps of Current sensor capabilities, so I can not use it as is but I would like to probe the motor battery voltage.
Is it possible use the BlackStork OSD's current sensor pins for only motor battery voltage monitor?
There are 3 pins for the sensor: GND, +12V and A.
What signal is pin "A" ?
and the +12V is an input or output voltage from OSD ?
Thanks in advance for your feedbacks
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Sold||Vizion OSD with current sensor ($50 shipped) + video switch||VasMan||Aircraft - General - Miscellaneous (FS/W)||1||Dec 21, 2008 04:21 PM|
|Discussion||Black Stork OSD Current Sensor Calibration Question:)||danje||FPV Talk||6||Oct 31, 2008 12:25 PM|
|Sold||Vizion OSD (V3) with Current Sensor - $80.00 SHIPPED||VasMan||Aircraft - General - Miscellaneous (FS/W)||1||Jun 13, 2008 01:39 AM|
|Help!||Current sensor||rc-pilot-freak||DIY Electronics||17||Jan 18, 2007 05:04 PM|
|Discussion||Current sensor/limiter||dusty IV||DIY Electronics||3||Aug 07, 2006 03:13 PM|