I'm starting to build a UAV for my senior seminar project and I need your guys' input to help me graduate. I am completely new at this and I am really cramped on time

I've ordered this UAV
http://www.nitroplanes.com/4eluavrqprra.html

With this ESC
http://www.nitroplanes.com/30aelbrescsp.html

Now, I need a motor, tx and rx, servos, and FMA copilot

First up, the website recommends this motor
http://www.nitroplanes.com/a2haoubrmo10.html

But they are out of stock, so I was wondering if this motor will be a good substitute
http://www.nitroplanes.com/al3701brmo1.html

Next I need a tx and rx so I was wondering if this rx
http://www.nitroplanes.com/mksprre.html

would work with this tx
http://www3.towerhobbies.com/cgi-bi...&I=LXSYK1**&P=0

and if they do, which air frequency would I order? The channels range from 11 to 60

next, the site recommends 9g mirco servos, will these servos work since they don't have 9g servos?
http://www.nitroplanes.com/7gmicrorcservo.html

Flying is not an important issue right now, what I absolutely need to know is if the tx and rx will work together and will the motor and servos serve as a good substitute to the site's recommended parts

thank you again

If you get all that, you still won't have a UAV. You will have a radio-controlled aircraft, but it won't fly itself. You do realise that don't you?

Also, if you do plan on building a UAV, I suggest you post in the UAV forum:
http://www.rcgroups.com/uav-unmanned...-vehicles-238/
..a

http://u-nav.com/