I would start off the thread in the right direction, but I'm on vacation away from my models

Let's see them!

Ron

Guess I will post some pictures of mine. Its a work in progress and a little bit different. All custom built from the chassis to the body.













Mike

Here are a few of my old ones.........................

"poormans high lift"

By twisted84toyota, shot with CYBERSHOT at 2006-12-18


my Stroppe bronco and FJ40

By twisted84toyota, shot with CYBERSHOT at 2006-02-03

TXT super

By twisted84toyota, shot with CYBERSHOT at 2005-07-28

H2 hummer on Xfactor axles

By twisted84toyota, shot with CYBERSHOT at 2005-07-26

heres my collection,i just sold the blazer cc01(regret that)my yota is a roller but no where near complete.the yota consist of:
rc4wd bruiser chassis
rc4wd r2 tranny
holmes hobbies 1000kv crawlmaster
home made stainless steel leafs up front
custom 4-link rear suspension with custom coil spring suspension
lots of machined spacers
CAC aluminum beadlock rims
SDI trail doc xl tires
kamtec bruiser clear glass
highlift front axle with custom above axle servo mount(hitec 645)
tlt rear axle with rc4wd strigh axle kit
custom scale 79 yota dash(not pictured)

the highlift is full 4 linked on 1.9"s the blue jeep is fully home made chassis
the nitro crawler is coming along slow but i did do a test run,i like it ,it looks promising.the buggy is an ofna hyper7 pbs

Here is mine. Not your typical scale, mine is 1/24th.

Completly custom from a brass chassis and leaf springs, all the way up to custom seats.

Here is a video:

SSMT Test 1 (1 min 35 sec)

nice rides
i really like the ssmt

Those are some nice trucks.

Here are my little table top crawlers.

Hand crafted when my eyesight was better...... They still work perfectly.

-Todd

This one I built from a Tamiya education set. One of my first fabrication projects. The steering front axle was difficult but I learned alot. I made this one in 1999. It still works perfectly.

-Todd

Here is a custom 1/24th scale crawler I began but never finished because I got into racing fast electric boats for awhile.

Unfortunately, this project has never been completed but is still shelved and ready to go when I get back around to it. The front axle was the hardest part. The rest should be easy.

-Todd

Here are a few more projects of mine. I still have many boxes of parts waiting for the mood to strike me into building trucks again.

-Todd

Here are a few of my new "baby"..will lose its cherry this weekend in our first season opener competition..

Also some pics of my "Super" with the Pimp Kane chassis..

Sweet.

Here is my AX10. Since the pictures it has been polished (all green removed) and 4 linked in the rear with a TCS aluminum plate, and went to 11.1 lipo

Holmes Hobby 7T Puller
Mamba Max

And a Youtube video... Let me know what you think.

Axial AX10 (1 min 12 sec)