|Dec 30, 2007, 02:33 PM|
What to do if your current sensor is reading incorrectly
If your eLogger or Data Recorder Electric Expander current sensor is inaccurate, what may be happening is that your setup has a steady non-zero draw after powerup. We're seeing more and more of this with larger ESC's/Motors.
To fix this, simply install th Eagle Tree Windows application version 5.66 or later, and click "Tools, Rezero Current Sensors."
This works with our eLogger, our Electric Expanders, and our new Servo Current Sensor. It is especially useful with the Servo Current Sensor, since servos draw a small amount of current even when they are not moving.
Just make sure that there is no current draw through the sensor when doing the Rezero. Also make sure that you have a battery connected to your eLogger during this step.
NOTE: All eLogger V3 units are shipped with the zero current pre-calibrated, so this step should not be necessary.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||O.T. What to do if your F-22 canopy fails.||Kevin Cox||Electric Ducted Fan Jet Talk||1||Apr 24, 2006 09:38 AM|
|What do you do if your frequency isn't open?||psycho_klown66||Beginner Training Area (Aircraft-Electric)||13||Oct 19, 2004 10:42 AM|
|What to do with your new Phx 10||Shawn Palmer||Castle Creations||0||Oct 21, 2003 02:16 PM|
|What to do with your ACE Simple series Wing||Cybear_GBG||Parkflyers||14||Aug 24, 2003 02:58 AM|