|Aug 04, 2007, 10:04 PM|
United States, CA
Joined Dec 2001
Charging Multiple Packs with CellPro or BalancePro Charge Protection Modules
Per the instructions for either the FMA CellPro or BalancePro Charge Protection Module (CPM), multiple CPMs may be daisy-chained in a series-charging arrangement to provide overcharge protection when charging multiple lipo packs simultaneously from a single charger.
Unlike the normal paralleled multi-pack setup, I'm not clear on this series arrangement. When any of the CPMs shuts off charge to its respective pack, what actually happens? Does the CPM shunt the pack out of the series loop, whereby the charger is supposed to sense the reduced voltage across the remaining packs being charged and adjust its voltage output accordingly?..... or does the CPM block charge current to the pack but still allow its voltage to be sensed by the charger?
TIA for any clarification.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Charging and Balancing Multiple packs With the LBA6||Tom Frank||Batteries and Chargers||10||Jul 13, 2006 10:13 PM|
|Charging multiple packs with Triton??||Astro30||Batteries and Chargers||5||Sep 23, 2004 07:56 AM|
|Charging multiple packs||jhearn||Batteries and Chargers||1||Jul 14, 2003 10:37 AM|
|Question||Charging multiple packs??||1 Flight Wonder||Batteries and Chargers||6||Feb 15, 2003 12:03 PM|
|Charging multiple packs at the same time||BleuBuck||Power Systems||13||Jul 07, 2001 11:59 PM|