1 Gecko OSD board that I purchased from MR. RC-Cam for beta testing of his final product “Inspire OSD”.
Features
Clock/Timer: Displayed as local time, UTC time, or elapsed flight time.
R/C Control: Remote operation of data display and camera shutter.
R/C Glitch counter: Up to 999 glitch events can be recorded.
Photo/Event Counter: Up to 999 photos or events, with GPS data, can be recorded.
Altitude and Speed: Altitude can be MSL or AGL. Accurate ground referenced speed.
Tachometer: Motor speed, up to 65K RPM with 100 RPM resolution.
Station ID: Interval-based station ID (ham call sign or station name).
GPS Heading: Real-time Course degrees.
GPS Coordinates: Real-time latitude and longitude.
R/C Signal strength: On-screen signal strength indicator.
Motor Power: Display volts up to 40VDC and current up to 50 amps continuous.
Aux Voltages: Display R/C receiver/servo voltage.

My findings and short review are posted here. The thread if read from the beginning starts with the conception of the OSD board and contains a lot of good information from other beta testers also. A link to my video is posted here. Pictures are here. This also includes micro gps and the tach sensor but you will need to purchase 2 of the earth magnets for the RPM
I also have the instructions for the firmware version that is installed on this particular board. (3.0 rev C) I believe.
Additional parts can be purchase from his website

Paypal only
$190 shipped priority mail con US only.
Regards
Zeek

pm sent.

victor

Email's and PM's answered. Still available....

Zeek

SOLD

Thanks