 |
 |
 |
|
Jul 18, 2006, 05:30 PM
|
|
Copenhagen, Denmark
Joined Jul 2003
243 Posts
|
Stock HB 3d or new baldes for piccolo pro??
Im in doubt. I have a piccolo pro but the blades are busted and they are quire expensive (220 dkk). A new hb 3d is 1000 dkk and brushless motor - quite tempting.
Is the stock HB 3d including the motor any good? i.e. do I have to do a lot of upgrades before having a good setup. I was thinking about using the dd tail from the piccolo as I have a CC10 and 4 servos may by too much. |
|
|
|
| |
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Castle Creation Pheonix 10 handle too little AMP for Piccolo Pro? | xen | Micro Helis | 25 | Apr 18, 2003 09:57 AM |
| Possibly the ultimate tail motor setup for the Piccolo Pro | Eco8gator | Micro Helis | 1 | Feb 24, 2003 08:24 PM |
| New Software for Orbit Pro 5 Amps on LiIon! | vkmaynard | Batteries and Chargers | 73 | Feb 24, 2003 09:09 AM |
| 6 cell Kokam pack for Piccolo Pro | Eco8gator | Micro Helis | 5 | Feb 17, 2003 10:58 AM |
| Speed 400 4.8 volts direct or geared drive for SS Pro??? | soholingo | Power Systems | 8 | Sep 10, 2001 08:36 PM |
|
|