|Mar 28, 2006, 10:40 PM|
E-star models Comet F3A pattern plane...
Purchased around Christmas and started assembly. Fuse has been assembled, spackled and sanded and is basically ready for coveing. Pushrod tubes have been installed as well. The tail surfaces are built and covered (white) but could easily be recovered if you prefer another color. The wing sheeting has been glued together but the wing still needs final assembly/ The kit is all laser cut with plans and instructions, and all the pieces are there. I just do not have the time and patience to finish this one. The only flaw is the canopy is slightly warped from shipping but could easily be straightened out if heated gently in warm water I think. Hinges and basic hardware is included but wheels are not. If I have some that fit I will throw them in as well.
Weight:20-21 oz. (560-600g) 4,5 channels
Kit retails for $95 new.
I may have some servos, brushless outrunner motor, and a set of retracts I was going to install in it (stock form is fixed gear) if someone is interested in purchasing those too.
Asking $75 shipped CONUS
Would consider trades, especially a GY240.
Last edited by papasmurf; Jun 18, 2006 at 10:29 AM.
|Apr 02, 2006, 08:17 PM|
Bump...have brushless power setup I would sell in addition as well. Would consider full/partial trades for a large outrunner that would power a .40 size aerobatic plane or an ESC that can handle 45-60 amps and 4-6 lipos.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|E*star Models Comet||Mike A||Parkflyers||18||Oct 28, 2006 07:14 AM|
|Sold||E-star models Comet F3A||papasmurf||Aircraft - Electric - Airplanes (FS/W)||0||Jun 18, 2006 10:42 AM|
|Indoor 3D CAP/EXTRA/SUKHOI from E*STAR models||snaproll||Scratchbuilt Indoor and Micro Models||17||Dec 10, 2003 10:58 PM|
|3D CAP from E*STAR models||snaproll||Sport Planes||32||Dec 09, 2003 11:11 AM|
|E-Factor electric F3A pattern plane||ShredAir||Sport Planes||0||Apr 21, 2001 12:06 AM|