|Mar 16, 2006, 09:27 AM|
BIG stator (+45mm) build thread.Everyone`s invited!
I was thinking that it could be interesting to have a BIG stator thread were builders could share experienses and information.
I haven`t done much on mine yet...but i know outhers that have.
Powerditto is the site to start at.
My goal is a motor that turns a 10-12 inch prop at ~12000 rpm on 3 or 4 cells LiPo.
|Mar 16, 2006, 10:58 AM|
Dimension on stator,
50,2 mm x 13 mm, 26 statorplates.
Original can inner dia 58mm, I`m not going to use that. I make a custom with 55mm ID and use 15x4x2 neo`s.
Magnets found here
Rotor calculator is here
So far i only winde with 1,8mm wire, 4 turns....next wire I have is 0,7, so must get some other dia, like 1,4 maby...
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|42" S.O.S. Build Thread||joe manor||Slope||80||Mar 28, 2012 01:43 PM|
|2.4 m Concorde 4 x BL EDF's build thread!!!!!!!!! its going to be BIG||Paul DF jet man||Electric Ducted Fan Jet Talk||70||Nov 14, 2008 12:12 AM|
|New Product||Millennium PTU!! Its like there's a party on my back and everyone's invited!||Smokescreen38||Micro Ready-to-Fly||12||Jun 19, 2007 10:01 PM|
|It's not another Sopwith Triplane - Austin Triplane build thread||Looooeeee!||Scale Kit/Scratch Built||58||Dec 03, 2005 02:44 PM|
|3D foamy Katana S build thread.||Thomas Manson||3D Flying||35||Oct 26, 2004 02:46 PM|