|Feb 13, 2006, 03:45 PM|
Joined Mar 2005
Assigning a switch on a FF9 transmitter
I need to assign a switch on my Futaba FF9 transmitter for the purpose of taking photos with an additional servo plugged into channel 8 or 9 on my 9 channel Futaba receiver.
Ideally one of the switches on the front left of the tranny.
Any idea on how its done as I can't make much sense of the manual.
|Feb 14, 2006, 03:53 AM|
Push mode/page for 2 seconds.
Turn right button to AUX-CH.
Push the button.
Arrows up/down to select channel.
Turn button to select switch/pot.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Question||TRN switch on CX2 transmitter||grapeflyer||Coaxial Helicopters||1||Mar 01, 2007 11:45 PM|
|Discussion||Toggle switch on BCX2 Transmitter purpose??||mcf34||Coaxial Helicopters||1||Jan 04, 2007 02:46 AM|
|Snap Roll Switch on JR XP8103||KAMarks||Hand Launch||2||May 24, 2002 09:26 AM|
|Can an arming switch on esc be bypassed?||omega blood||Power Systems||4||Feb 22, 2002 03:03 PM|