|Nov 30, 2005, 02:42 PM|
Joined Oct 2003
Servo torque for 3D plane?
How much torque do you really need on a 3d plane like the Hot rod mini or any other 7-10oz plane, bipe or single wing such as a 75% 3dbatix extra 330 (28" wing)?
I am looking at the AUW. I have been using the rc-Dymond D44's (weight 4.4g, 15oz torq) with very good results. I thought about the Blue bird 303 (3.6g with 10oz torq)
One more point, I normally use 2 servos for ailerons.
|Nov 30, 2005, 04:57 PM|
Joined Feb 2005
Right on, 10oz torque is fine for 7-10 ounces plane. I like the 5.4g GWS picos. I prefer a single servo installation for ailerons. When doing that, I will use a 7g 15-17oz torque servo for good measure.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|New method for 3D plane connect, Look my DIY 3D plane.||UNIX||3D / Fun Fly Fuel Planes||4||Aug 20, 2004 10:19 AM|
|Plans/ideas for 3D plane with airfoil for blucor?||NewbieX||3D Flying||0||May 31, 2004 12:11 PM|
|Servo recom. for lrg plane crashed once by elev. flutter||Brad B.||Hitec/Multiplex USA||4||Apr 20, 2004 11:23 AM|
|looking for a 3d Plane||kushal_22||Parkflyers||23||Jul 31, 2003 02:48 PM|
|Right thrust for 3D plane||TrentO||Sport Planes||6||Jun 24, 2003 06:17 AM|