|Aug 17, 2005, 03:13 PM|
Joined Nov 2004
My Tail rotor won't spin, how to mix? Help
I am a newbie into Micor heli. I have a Dragonfly FP with seperate electronics.
The TX is GWS 4channel, RX is GWS 6 channel. GWS PG-03 Gyro.
My question is that my tail rotor won't turn. When the heli tail spins, I can see the red light on the GWS Gyro I guess indicating that it's spinning. But the tail rotor won't spin. I have tested the tail motor to make sure it's good.
So do I need to mix the rudder (channel 4) ? Don't know how this works, any help is appreciated.
|Aug 17, 2005, 03:18 PM|
San Carlos, California, United States
Joined May 2002
You can't do mixing with a GWS 4 channel radio.
There's ways to do mixing on the heli including a separate mixer, a TREC ESC, etc or use a HH gyro.
This is all explained in the EHBG.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Help!||Blade CP//DD mod and tail motor won't spin!||n3ok318||Micro Helis||3||Jan 01, 2006 09:34 AM|
|Question||Help!!!!!!! Dragonfly main rotor won't arm!!!!!||Ekim||Micro Helis||2||May 04, 2005 11:32 AM|
|HB - my tail rotor stopped! Help!||albireo||Micro Helis||6||Aug 24, 2003 08:26 PM|
|My Tail Motor won`t engage||kushal_22||Micro Helis||9||Aug 17, 2003 10:10 AM|
|Tiger Moth Help - My heat sink won't fit...||DennisG||Parkflyers||13||Nov 19, 2002 04:35 PM|