Hello All,

I gotta make more room in my garage!

Here is a "Slow Stick" version of my Depron Dragon http://www.foaminfusion.com/UAV.html twin boom pusher. It breaks down very flat for shipping/transportation and the wing is 3 piece. The A tail comes apart with a pin.

It has custom landing gear and a motor riser to keep the prop off the ground. The center wing section uses kevlar thread wrapped carbon tubes front and rear and the outer panels have carbon rods front and rear that slid into the carbon tubes of the center section, you just tape the secons fron sliding off.

oh, also comes with CF servo push rods. DOES NOT COME WITH ELECTRONICS.
My Depron Dragon carries a 14 oz payload easily and with the same motor set-up this will too.

I did a post on one of my flights with here: http://www.rcgroups.com/forums/showthread.php?t=381986
It flys great (NOTE: you will need V tail mixing on your radio) .

If you want a great A/P platform already built, with EZ to find parts, here it is!

$80 plus shipping from 95630. Shipping size is approx: 36" x 16" x 6"... figure 5 lbs.

EMAIL me HERE: hobiehawkrc@yahoo.com

Thanks guys!

CJS

A few more photos...

How much shipped to 92708?

Just re-posted size/weight info for shipping...

WillHaney, about $10

I'll take it for 65.00 including shipping to 85202 if no other takers. Funds already in my PayPal account.

Qualcity

Just posted it tonight... so I'll wait a couple days, but will keep your offer in mind. I put quite a bit of effort into the project so I'd like to get what I asked if possible.

Thanks,

CJS