 |
 |
 |
|
Dec 30, 2004, 08:26 PM
|
|
|
Joined Oct 2002
301 Posts
|
Mountain Models MiniFlash Build Question
I am in the process of building the wing for the Miniflash. The instructions state: "Position the 3/32" balsa rib reinforcement into place and glue."
I believe this reinforcement is glued to the inside rib but I am not completely sure. I would appeciate your feedback. Thanks |
|
|
|
|
|
Dec 30, 2004, 11:07 PM
|
|
Ithaca, NY USA
Joined Mar 2001
4,370 Posts
|
The 3/32" piece is glued to the inside of the inner most rib. By inside, I mean the side towards the other ribs. The inner most rib will be pulled in when you shrink the covering so this piece gives the rib strength. The outermost rib does not need this because of the wingtip.
Doug Mountain Models |
|
|
|
|
Dec 31, 2004, 07:38 AM
|
||
|
Joined Oct 2002
301 Posts
|
Quote:
Thanks Doug!! |
|
|
|
|
|
|
Dec 31, 2004, 02:44 PM
|
|
Auburn, Washington USA
Joined Jan 2001
12,919 Posts
|
Picture
In case it helps, here's a pic of one of these braces installed.
|
 |
Latest blog entry: Diverted from R/C to Free Flight (of a...
|
|
Jan 01, 2005, 07:40 AM
|
||
|
Joined Oct 2002
301 Posts
|
Quote:
|
|
|
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mountain Models Miniflash: Build question | MikeTwain | 3D Flying | 17 | May 11, 2005 09:05 AM |
| Miniflash build question. | Eyefly | Parkflyers | 5 | Jul 04, 2004 05:13 PM |
| Free Shipping on Mountain Models MiniFlash | Zhack | Aircraft - Electric - Airplanes (FS/W) | 0 | Mar 27, 2003 01:53 PM |
| MY Mountain Models MiniFlash Build | Aldur | Parkflyers | 44 | Mar 15, 2003 12:49 AM |
| Mountain Models Miniflash Speed-Wing | sukhoi26mx | Parkflyers | 21 | Dec 09, 2002 01:38 PM |
|
|