Espritmodel.com Telemetry Radio
Reply
Thread Tools
Old Dec 26, 2004, 02:50 PM
Registered User
Joined Dec 2004
2 Posts
etching/engraving PCB via a small CNC

I do alot of prototyping for our robot team at Latech. I would like to build a small CNC or engraver so I can make some PCB.

I came here because of a reference so I was hoping someone could help me.

Some places I have found that have these kits are

Stepperworld.com ( FET-3 )
hobbycnc.com ( http://www.hobbycnc.com/cncpackages/...g/4aupcpkg.htm )

These are the motors and drivers, but are these good kits? Where do I get the rails for the table?

Thanks,
Nick
NickLatech is offline Find More Posts by NickLatech
Reply With Quote
Sign up now
to remove ads between posts
Old Dec 26, 2004, 06:08 PM
Registered User
Joined Dec 2004
2 Posts
I found a XY table on ebay http://cgi.ebay.com/ws/eBayISAPI.dll...sPageName=WD1V

if I use this with a electronics kit from say hobbyCNC.. that would be pretty close to a complete setup? All I would have to add would be a Z travel.

Let me know what yall think

Nick
NickLatech is offline Find More Posts by NickLatech
Reply With Quote
Reply


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion small CNC job theKM The Builders Workshop 6 Aug 17, 2006 01:28 AM
Photo Etching - a "How To" for PCB boards and making small metal parts. planeman Scratchbuilt Indoor and Micro Models 81 Jan 04, 2006 02:49 PM
See small cnc router F/S Landarts The Builders Workshop 4 Jun 17, 2004 10:04 AM
Anyone interested in buying a small cnc router Landarts The Builders Workshop 3 May 14, 2004 08:04 PM