|Sep 05, 2004, 01:58 AM|
ESC not recognized by Phx-link
I had three Phoenix speed controls which went to Castle at the end of Aug for updating. Repair invoice 24897.
I have just tried to configure them using the Phx-link. The P-35 and P-45 both cause the Phx-link software (1.02) to give message "Internal Error - Settings not found for this controller type" and close.
What gives? Do I need to use one of the beta versions?
|Sep 05, 2004, 02:07 AM|
Yep, Try 1.05b. It worked for me. I couldn't even install 1.02 on two different XP pc's. 1.05 works great. Fixed the internal errror prob for me.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Question||Phoenix 45HV not recognized by Castle Link||Xnaron||Castle Creations||2||Aug 05, 2006 10:40 AM|
|Discussion||Phoenix 80 not detected by castle link...||jameotron||Castle Creations||5||Jul 30, 2006 09:01 PM|
|CC 25 Phx Link ESC not connected?||mdlifcrisis||Castle Creations||19||Aug 05, 2005 10:48 AM|
|Question||Program two ESC in Parallel using Phx-Link?||LexTalionis||Castle Creations||4||Oct 29, 2004 05:41 PM|
|Question||PHX-Link for brushed esc?||newracer||Castle Creations||3||May 10, 2004 10:23 AM|