|Feb 10, 2004, 06:33 PM|
CD-Rom motor for sale
20 turns of 26g wire in star wind, weighs 33 grams. Made up the mount and the bearing tube from aluminum and used the original cdrom 3mm shaft for the prop shaft, just had to take a dremel to it while it was spinning so I could put a c-clip on the back of it.
It turns a 6.5x5 prop at around 6 amps on a 3s lipo pack. It has 12 N45 magnets glued in to replace the stock weak magnet.
Requires a 3mm prop adapter.
$30 shipped in the US
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Piccolo Cd-rom motors for sale||rbeall04||Power Systems||0||May 05, 2004 12:04 AM|
|rewound cd-rom motor for direct drive tail rotor||Ron van Sommeren||Electric Heli Talk||0||Apr 26, 2004 08:28 AM|
|Brushless CD-ROM motor for GWS warbirds||beanie||Power Systems||0||Mar 01, 2004 08:58 PM|
|Anyone using a CD-ROM motor for a tail motor?||GBR2||Micro Helis||5||Jan 29, 2004 09:29 PM|
|32X CD-Rom Drives--FOR SALE||kist2001||Aircraft - Electric - Airplanes (FS/W)||0||Apr 23, 2002 04:33 PM|