|Jan 08, 2004, 12:44 AM|
Is my Scratch Built a good 3D trainer?
I have not flown 3d... but that didn't stop me from making a scratch built plane over XMAS from fanfold foam...
Evaluate my design and let me know if there are structural mistakes I made that will prevent me from learning how to 3d..
It is powered by an AXI 2212/34 and 3s Lipos (etec and irate)
It weighs about 12 oz all up...
* Note... the nose flaps of the plane folds in to cover the battery along the lines
|Jan 08, 2004, 04:48 PM|
I was thinking that the rudder might be too small too. I have been trying to hover and knife edge, and I think it might be causing me some difficulties..
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|My scratch built||Erez-E||Parkflyers||1||Nov 25, 2002 12:00 AM|
|My Scratch built Micro F-16||chiefwinston||Electric Ducted Fan Jet Talk||6||Nov 10, 2002 06:13 PM|
|Started my scratch built mimi heli||Gonflyin01||Electric Heli Talk||1||Apr 30, 2002 08:16 PM|
|My scratch built trainer||Tyson||Beginner Training Area (Aircraft-Electric)||2||May 28, 2001 02:44 AM|
|My scratch built Lite/dusk stik.||Dandi6065||Parkflyers||4||May 14, 2001 12:51 AM|