SMALL - espritmodel.com SMALL - Telemetry SMALL - Radio
Reply
Thread Tools
Old Feb 22, 2013, 05:28 AM
Joined Jul 2011
671 Posts
Discussion
DJI Naza-M Assistant Software Error Code List

Here is the Naza-M Assistant Software Error Code List. Please read so that you can have a better understanding of the errors and how to fix it!

CFG-ERR
Configuration error, this may be caused by firmware upgrade from the old version, or abnormal Tx calibration. Re-calibrate your transmitter, power cycle your controller, and check all of the parameters.

VOL-LOW [4]
Voltage low

SN-ERR
Your S/N is not available, Please contact your dealer (Place of purchase)

VOL-LOW[6]
Voltage low

IMU-ERR
IMU ERROR,Please contact dealer. (Place of purchase)

X1-ERR
You’ve chose parameters tuning by X1/X2 channel with Tx Knob, but no signal detected on X1/X2 input channel, or Tx didn’t powered on.

X2-ERR
You’ve chose parameters tuning by X1/X2 channel with Tx Knob, but no signal detected on X1/X2 input channel, or Tx didn’t powered on.

PMU-ERR
Please check the connection among battery, MC and PMU.

RX-ERR
Please make sure you are on the RC page of the NAZA Assistant Software, select the right receiver type or check the receiver connection, after that power cycle your controller to take effect.

COMPASS-ERR
Compass data is abnormal, please restart your Controller, if you still get this error, please contact your dealer (Place of purchase)

ERROR [25]
IMU initialization failure, may be caused by crash. Please contact dealer (Place of purchase)

ERROR [26]
Please perform Advanced Calibration.

ERROR [27]
GPS not calibrated, or magnetic field interference. Please calibrate GPS again in good condition.

Please contact your dealer for all technical support questions
We hope this answers your questions!
DJI INNOVATIONS is offline Find More Posts by DJI INNOVATIONS
Site Sponsor
Last edited by DJI INNOVATIONS; Feb 26, 2013 at 09:55 PM.
Reply With Quote
Sign up now
to remove ads between posts
Reply


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Help! DJI Naza Assistant software wont run Andjons Multirotor Talk 10 Aug 15, 2013 07:18 AM
Help! DJI Naza M Assistant 2.0 and 2.02 bolarobric Multirotor Talk 13 Feb 07, 2013 09:52 PM
Build Log DJI F550 NAZA ARF COMPLETE BUILD and DJI NAZA ASSISTANT w/ TX CALIBRATION >VIDEOS< patrick21x Multirotor Talk 11 Nov 30, 2012 07:13 PM
Help! DJI F450 NAZA/GPS will not connect to assistant software, any ideas would be great. jasper7821 Multirotor Electronics 2 Oct 24, 2012 05:53 PM
Discussion dji naza error code vol low 4 homersainty Multirotor Talk 1 Jul 22, 2012 09:04 AM