|Feb 15, 2013, 06:37 PM|
how to determine possible bad cell?
have a 5 cells receiver pack buried in plane..thought it was new.
it is NIMH..say 1600 mah capacity.
what should I set my charger at to test it?
1.1 volts/cell cutoff? 1.4 volts/cell max... ?
charge at .1C discharge at .3C or so
how much of capacity should it have before it gets tossed
what will peak pack voltage be for a 5 cell 7 volts ?
thanks..sorry ..been out of the game for a while.
|Feb 16, 2013, 01:17 AM|
Joined Oct 2004
Individually, perhaps. In series, definitely not as this may cause reversal and permanent damage to lower capacity cells within the series pack.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Help!||How to determine the correct simulator cable for a Tx?||tmbridge||Beginner Training Area (Aircraft-Electric)||14||Jan 11, 2013 03:25 AM|
|Discussion||how to determine 123 cells are good or bad ?||rcmarty||Electric Heli Talk||1||May 03, 2007 10:32 AM|
|Question||How do you determine if a motor is bad ?||Obake||Electric Motor Design and Construction||3||Feb 10, 2006 04:27 PM|
|How to determine if a brushed motor is bad?||darrell_f||Power Systems||21||May 06, 2004 05:18 AM|
|How to determine bad LiPoly cell?||pwkpete||Batteries and Chargers||5||Apr 03, 2003 09:00 PM|