5 x 3D Planes: 41" 3DHS EDGE, Skying 48" MXS, EF 60" EDGE 540T, Techone Su31, Wattapl
Hi there. I have for sale 3 3D planes.
First up is a Huck Buck from 3DHS (41" Edge) It is like new with a 72g omega motor **(no servos)**, spinner from Extreme Flight and APC 12x6 prop for $120.
Next we have a used Skywing 48" MXS foamie/fuselage 3D plane. It comes with Dualsky Xmotor 3542CA-6T, Castle Creations 50a ESC, 4 x Tower Pro MG90s Micro Servo. This thing has little to no damage. Tail wheel is wobbly and rudder has scraped on one hucks and landings and other than that it runs great. All for $200
The last and the least is my little Tech One RC 4 Channel SU 31 EPP built and ready to go. Everything works. Had some rough landings but is in really great condition. Needs good hinge tape on rudder and elevator. Motor mount has been repaired but is stronger than new. Great 3d Trainer!! Includes:
Fuselage length: 1070mm (42.1in.)
Wingspan: 1000mm (39.4in.)
Flying Weight:650--710g (with battery)
Motor: AS2216 KV 1250
ESC: 30 Amp
Propeller: APC 10x4.7sf
Servo: 8-12g micro servo*4pcs
4 x 3s 1300mah 20c lipos
1 x 3s 1000mah 40c
$125 with batteries, $95 without. Just need an RX.
NIB Skywing 48-in EPP Edge-540 (Full Fuse Blue) $140
******************Buy all for $900!!! $ 160 savings.***********************
Will sell airframes only too:
3DHS 41" Edge: $95
EF 60" Edge: $190
Skywing 48" MXS: $85
SU31 Airframe only N/A
***AL PLANES ARE LPU****
Thanks for looking.
Just chiming in here, I have the Motrofly DM4315-480 in my 60" edge with a 15x7 prop pulling around 1500 watts. For a real rocket you can prop up to a 16x8 (1700 watts!) which some of the guys are doing. The thing has unlimited stump pulling power. I run it with EM 35C 6s 3300's and glacier 6s 3300's and get anywhere from 5-6.5 mins depending on the throttle management.
If you still have these planes when my next paycheck comes in, we might need to have a talk about one or two of them :P
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|For Sale||5 x 3D Planes: 41" 3DHS EDGE, Skying 48" MXS, EF 60" EDGE 540T, Techone Su31, NIB WP||Wingbreaker||Aircraft - Electric - Airplanes (FS/W)||4||Feb 10, 2013 06:44 PM|
|Discussion||Comparison 3DHS EXTRA 300 SHP 47” and EF MXS-EXP 48” and PA EXTRA 260||Jack Skip||3D Flying||115||Nov 10, 2011 04:56 PM|
|Found||Looking for a 3D Hobby Shop (3DHS) 41" Edge 540 or other 3d plane.||GlockDoc||Aircraft - Electric - Airplanes (FS/W)||6||May 26, 2011 12:29 AM|
|Discussion||3DHS Edge + EF MXS = ARF Bash!||JimTMich||3D Flying||9||May 08, 2011 06:09 AM|