|Feb 09, 2013, 09:44 AM|
Joined Aug 2006
Help with CNC wiring!
I am a CNC newbie, just assembling my foam cutter, and need to extend the wiring to stepper motors... I am not able to source this where I live, but am visiting the US in a couple of weeks, so am planning to order from mouser or similar..the motors are bipolar type, 1.8A, and the wiring I need to extend (by max. 2m) is labelled as 24AWG.Does anyone have any recommendations, from Mouser or otherwise? I'd really appreciate a nudge in the right direction!
|Feb 09, 2013, 10:10 AM|
If my memory serves, I got my wires from the local home store (Home Depot) and used common wiring usually used for sprinkler controls. Nothing really exotic. I did use silicone insulated wire for the power to the bow because I liked the flexibility of it...available at the hobby shop...normally used for RC battery leads.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Help with wiring an H-bridge||dmccormick001||DIY Electronics||27||Feb 10, 2013 05:45 PM|
|Discussion||Xieda wiring help needed||treff||Beginner Training Area (Heli-Electric)||3||Jan 27, 2013 12:32 PM|
|Help!||Lipo 2s balance wiring help please||dzgn||Batteries and Chargers||3||Jan 26, 2013 11:05 AM|
|Discussion||Wiring/soldering help with 900mhx system||pete914||FPV Talk||11||Jan 20, 2013 04:20 PM|
|Help!||need some electronic wiring help||abletowinginc||DIY Electronics||0||Jan 14, 2013 08:12 AM|