Hi guys from the title above i have a brush less esc with a 12T sensorless motor. I am trying set this thing up. I managed to get the thing going but reverse to too slow. I am using a acoms 27Mhz transmitter.

All trims are set to 0.

Iv followed the instructions that came with the esc but no luck.

I have even played about with the programming card to get the correct feature i want to accept reverse, even though reverse works but too slow.

What am i doing wrong?

Crossposted here: http://www.rcgroups.com/forums/showt...9#post24092720