SMALL - espritmodel.com SMALL - Telemetry SMALL - Radio
Reply
Thread Tools
Old Feb 06, 2013, 10:42 PM
FCC
Registered User
Joined Dec 2001
46 Posts
Discussion
Add channel to JR MAX-44

I just hacked into the JR MAX-44 four channel transmitter and added the fifth channel by connecting a switch as shown in first two pictures attached.

I knew it transmits six PPM pulses as the fifth and sixth channel servo holds the position to one extreme. I looked for some pictures of MAX-66 PCB connections on the web and by short circuiting the T15 and T13 terminals on the PCB found the fifth channel.

I was expecting the same for sixth channel on the other end of PCB for terminal T15D and T14 as shown in third picture but it did not work. I do not have oscilloscope to observe the correct signals, so if someone out there has experience or equipment to dig into this I am pretty sure to convert this to six channel radio.

Note: The same post exist in Aircraft-General > Radios > Add Channel switch, but since the thread is too old that’s why this has been reposted here!
FCC is offline Find More Posts by FCC
Reply With Quote
Sign up now
to remove ads between posts
Reply


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
For Sale JR 6102 6 channel radio channel 54 with manual mechengineer03 Aircraft - General - Radio Equipment (FS/W) 0 Jan 09, 2013 10:57 AM
Question JR MAX-44 radio repair help needed PLMS Radios 7 May 02, 2011 03:56 AM
Wanted JR grey cap Rx Channel 44 wanted. NEW222 Aircraft - General - Radio Equipment (FS/W) 0 Jan 28, 2010 04:34 PM
Sold jr tx modules channel 44-15-16 kcomqg Aircraft - General - Radio Equipment (FS/W) 4 Feb 12, 2009 03:13 PM
Sold Two JR R610M 6-Channel FM Micro Receivers -- $44 for both shipped SPasierb Aircraft - General - Radio Equipment (FS/W) 2 Jan 10, 2009 04:59 PM