Lumenier RB2205C-12 2400KV SKITZO Ceramic Bearing Motor
Thread Tools
Old Feb 05, 2013, 06:30 PM
bushpilot05 is offline
Find More Posts by bushpilot05
Registered User
United States, NJ, Flemington
Joined Feb 2013
7 Posts
eagle tree guardian

I installed and tested by moving on all axis,the control surfaces only move a small amount.Gains are all the way up. Control surf. move normally when using sticks.I am using dx5,but recently purchased dx7. could it have something to do with transmitter? receiver is 6 channel.
bushpilot05 is offline Find More Posts by bushpilot05
Reply With Quote
Sign up now
to remove ads between posts
Old Feb 22, 2013, 11:37 AM
moto mike is offline
Find More Posts by moto mike
Registered User
moto mike's Avatar
Joined Mar 2008
117 Posts
I haven't used the eagle tree but did use another 3 axis gyro the orange x. And control surface movements were small. I think that it reacts quickly enough that small inputs are all that is needed. If you have too large movements, the danger of airframe shaking oscillations result.

I think the recommendations are that you start with just perceptable movement when you twist it about by hand.
moto mike is offline Find More Posts by moto mike
Reply With Quote

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion eagle tree guardian bushpilot05 Radios 2 Feb 24, 2013 02:04 PM
Discussion easystar + osd eagle tree + guardian xipho3 FPV Equipment 1 Jan 04, 2013 10:40 AM
Sold Eagle Tree Guardian Stabilizer Crist Rigotti FPV Equipment (FS/W) 2 Mar 20, 2012 02:19 PM
Wanted Eagle Tree Systems Guardian shlomi4046 FPV Equipment (FS/W) 1 Nov 12, 2011 11:11 PM
Wanted Eagle Tree Guardian module ajhaggerty FPV Equipment (FS/W) 0 Oct 06, 2011 12:08 AM